







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Tremron Bathroom Remodeling: The Westminster Owner’s Guide
Tremron bathroom remodeling in Westminster runs $9,000 to $28,000 installed, depending on the size of the room, the tile and fixture selections, and whether we’re changing the rough-in. If your shower pan is holding water, your grout joints are cracking at the curb, or a tile has started to tent off the floor, we install Tremron-compatible systems and can give you a written price before any work starts. Call (833) 954-5086 for a free estimate.
Most Westminster owners find out something is wrong the same way: a soft spot underfoot near the shower, a hairline crack that keeps coming back after re-grouting, or water staining on the ceiling of the room below. By then the failure has usually been running for a while behind the surface.
Bradford Remodeling Co Westminster is an independent remodeling contractor. We’re not affiliated with Tremron, and we don’t manufacture or warehouse their products. We install and repair bathroom systems that work with Tremron materials and specs, and we put the scope and the price in writing first.
Which Tremron Models This Applies To

Tremron makes pavers and hardscape products, and many Westminster homes use their materials in outdoor and wet-area applications. When a homeowner calls us about a “Tremron bathroom” failure, what’s usually going on is one of three things: a Tremron paver or tile product installed as a shower floor or bathroom floor, a bath or shower surround built onto a substrate that was specified alongside Tremron materials, or a hardscape product that’s being repurposed indoors and failing because it wasn’t rated for wet, heated interior conditions. That last one is the gotcha we see most often in Westminster’s older housing stock, where a paver meant for a patio gets set in a shower pan and starts to spall within a couple of seasons.
Identify what you actually have before ordering anything. Look for a stamp or ink mark on the back of a loose tile or paver, check the original project paperwork if you have it, and measure the actual dimensions to the nearest sixteenth of an inch. Tremron products come in nominal and actual sizes that don’t always match, and a nominal 12-inch paver frequently measures 11-5/8 inches. If you order replacement material against the nominal number, the new piece won’t line up with the old field tile.
On the OEM-versus-aftermarket question: for a hardscape product like Tremron, matching the exact series and face style matters more than brand loyalty. A close aftermarket match in the same actual thickness, the same absorption rating, and the same finish will set and wear like the original. What you don’t want is a bargain substitute with a higher water-absorption rate. In a shower floor, that difference shows up as freeze-thaw spalling and efflorescence within two or three years.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Tremron Bathroom Remodeling Is Failing
- Hairline cracks that return after re-grouting. The grout isn’t the problem. Something under it is moving, usually because the substrate wasn’t properly bedded or the thinset has debonded from the pan.
- Soft or hollow-sounding spots underfoot. Tap across the floor with a coin. A dead thud instead of a sharp click means the tile has come loose from the substrate, and water is getting in behind it.
- Efflorescence, that white chalky bloom on grout or stone. Moisture is moving through the assembly and evaporating at the surface. In Westminster’s coastal-influenced climate, this often shows up on the north-facing or shaded side of a bathroom first.
- Grout or caulk joints opening at the curb and wall transitions. Those are the two places movement concentrates. When they open, water gets behind the tile instead of running off it.
- Staining or bubbling on the ceiling of the room below the bathroom. This is the one to take seriously. It means water has already traveled through the assembly, and the repair scope is bigger than a tile swap.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

In Westminster, a full bathroom remodel runs $9,000 to $28,000 installed. A small bathroom remodel runs $5,000 to $12,000. If the scope narrows to a walk-in shower installation, that’s $4,500 to $12,000. A tub-to-shower conversion lands between $3,500 and $10,000, a shower replacement runs $3,000 to $8,500, and a bathroom vanity installation runs $800 to $3,000.
What drives the range: the condition of the substrate once we open it up, whether the rough-in has to move, and the material selection. A bathroom where the pan, substrate, and waterproofing are sound is a much smaller job than one where the floor framing is soft. Every price we quote is a written line-item price before any work starts, not a number that gets adjusted at the door.
Every completed project is covered by the 365-Day Done Right Promise. If the work fails inside that first year, we come back and correct it at no charge.
DIY or Call Us?
Some things you can safely check yourself. Tap the floor for hollow spots, look behind the toilet and under the sink for staining, and check the caulk joints at the curb and wall transitions. Those are observation tasks, not repairs.
What we’d steer you away from is pulling up tile to see what’s underneath, or re-setting a shower floor without knowing what you’re setting it onto. This is where the failures stack up. The visible product – the Tremron tile or paver – is usually the last thing to fail. What fails first is the waterproofing membrane, the thinset bond, or the substrate underneath. If your shower pan is leaking, and you set new tile over a compromised pan, you’ve spent the material cost and still have a leak. Opening the floor to look is a demolition job, and getting it wrong can mean water damage that reaches a floor below before you’ve caught it.
If you’re unsure whether you’re looking at a surface issue or something deeper, call (833) 954-5086. A free estimate will tell you whether you’re facing a repair or a rebuild.
FAQs

A properly installed tile or paver bath floor with sound substrate and waterproofing should hold for 15 to 25 years. Westminster’s ocean influence means more ambient moisture and more thermal cycling than inland Orange County, which shortens that window on any install where the waterproofing was done poorly. Call (833) 954-5086 for an exact quote – estimates are free.
Sometimes. If the failure is a localized crack, a re-grout or a single-tile replacement can buy you years. If the substrate is soft or the waterproofing has failed, a repair won’t hold, and you’re better off replacing the assembly. We’ll tell you which one you’re facing before we quote anything.
A full bathroom remodel in Westminster typically runs two to four weeks once work starts. A targeted shower replacement runs closer to seven to ten days. The variable is the demo phase: once we open the floor, we know what’s actually underneath. That timeline and the price are both in writing before we begin.
We work from a documented roster of name-brand materials so every spec is traceable. For the broader bathroom, that includes brands like KraftMaid, Cambria, and Silestone. For Tremron-specific material, we source to the actual dimensions and absorption rating rather than the nominal label, and we confirm the match before ordering. Our technicians bring up to 22 years of experience to that matching work. Call (833) 954-5086 to schedule your free estimate.
Written by the team at Bradford Remodeling Co Westminster, serving Westminster and nearby areas.












