







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Schluter Driveway & Pavers: The Westminster Owner’s Guide
We install Schluter-compatible driveway and paver systems in Westminster, and most full paver driveway jobs land between $7,000 and $18,000 installed, depending on square footage, base prep and drainage. If you’re replacing a single failed component or re-setting a section, smaller repairs are quoted individually and usually scheduled within the same week, not the same day, because proper base and edge work takes time.
Owners usually find the problem the same way: a paver edge lifts after a rain, water pools against the garage apron instead of draining to the street, or a section of the driveway starts rocking underfoot. By the time it’s visible, the failure is almost always underneath, in the setting bed or the edge restraint, not in the surface itself.
Which Schluter Systems This Applies To

Schluter’s driveway and exterior paver work centers on its drainage and profile lines, chiefly the KERDI-LINE and KERDI-DRAIN systems for surface water management and the SCHIENE and TREP-E profiles for edge protection at driveway aprons, garage transitions and paver-to-concrete joints. The exact profile you need is stamped or printed on the part itself, usually on the flange or the underside of the anchoring leg. If the label is gone, measure the profile height in millimeters and match it to your paver thickness. A 60mm paver does not take the same profile as a 40mm one, and getting that mismatch wrong is the most common ordering error we see in Westminster.
For edges and transitions, genuine Schluter profiles are worth the small premium – the stainless and anodized finishes hold up to Southern California sun and marine-layer humidity far better than the generic equivalents sold at big-box stores. For setting bed and drainage components, a quality aftermarket equivalent is a reasonable call if it carries a manufacturer spec sheet. We don’t stock parts or carry them on a truck, so every component is sourced to your model and delivered to the job site. Bradford Remodeling Co Westminster is an independent service provider and is not affiliated with Schluter.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Schluter Driveway & Pavers Is Failing
Five things to look for, each with what’s actually going on underneath:
- Paver edges lifting or separating after rain. The edge restraint or profile has lost its anchor, or the base wasn’t compacted to spec. Once the edge moves, the pavers behind it start to migrate.
- Water pooling at the garage apron. The drainage slope has flattened, or a KERDI-LINE channel is clogged or set too high. Standing water against the foundation is the start of bigger problems.
- Rocking or hollow-sounding pavers. The setting bed has washed out or wasn’t compacted evenly. In Westminster’s coastal humidity, a loose bed turns into a settled bed within a season or two.
- Rust streaks or white efflorescence on the profile. Efflorescence is salt migrating through moisture; rust means the profile or its fasteners are degrading. Both point to water getting where it shouldn’t.
- Visible cracks or gaps at the driveway-to-garage transition. The transition profile has failed or was never installed. This is where water gets under the slab and where most winter damage starts.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

Here’s what the work runs in Westminster, with parts and labor broken out so the number doesn’t move on you:
- Full paver driveway installation: $7,000 to $18,000, including base prep, Schluter drainage and edge profiles, and compaction.
- Concrete driveway installation: $4,500 to $12,000.
- Driveway replacement (existing removed and rebuilt): $5,000 to $14,000.
- Paver patio installation: $3,500 to $11,000.
- Driveway sealing (existing pavers in good repair): $250 to $700.
The range is driven by square footage, how much base has to be excavated, drainage complexity and the profile or channel system your layout needs. Every project gets a written, line-item price before work starts, and the finished work is covered by the 365-Day Done Right Promise: if anything fails inside that first year, we come back and correct it at no charge.
DIY or Call Us?
You can safely check a few things yourself: inspect the edge profiles for looseness, clear debris from any drainage channel, and note where water pools after a rain. What goes wrong with DIY is everything below the surface. Setting a Schluter drainage channel to the correct slope, anchoring an edge profile into a properly compacted base, and getting the paver joint tolerances right take specific tools and experience. A profile set on an uncompacted base will fail again within a season, and you’ll pay twice. Our technicians have up to 22 years of experience on exterior paver and drainage work.
If you’re not sure what’s failed, call (833) 954-5086 and we’ll talk through what you’re seeing and what a proper repair looks like.
FAQs

How long does a Schluter paver driveway last? A properly installed system lasts 25 to 30 years or more in Westminster’s climate. The profiles and drainage components are usually the first parts to need attention, not the pavers.
Can the part be repaired instead of replaced? Often yes – a loose edge profile or a clogged drainage channel can be re-set or cleared without a full rebuild. We assess that on-site and give you a written price for the repair before touching anything.
How long does the swap take? A single profile or channel replacement is typically a one-day job. A section re-set with new base usually runs two to three days, and a full driveway rebuild is five to ten days depending on square footage and drainage scope.
How do you source the part? We identify your exact Schluter model from the unit or your measurements, source the matching component from an authorized supplier to your spec, and deliver it to the job site. We don’t stock parts and don’t carry them on a truck, so every part is ordered for your specific project. Call (833) 954-5086 for a free estimate on the part and installation.
We also work with KraftMaid, Cambria and Silestone on the interior side of the house, so if your renovation spans inside and out, one crew can handle the whole scope.
Ready to get your driveway squared away? Call Bradford Remodeling Co Westminster at (833) 954-5086 for a free estimate. Every price is written before any work starts, and every job is covered by the 365-Day Done Right Promise.
Written by the team at Bradford Remodeling Co Westminster, serving Westminster and nearby areas.












