







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
KraftMaid Windows & Doors: The Westminster Owner’s Guide
We install and service KraftMaid-compatible windows and doors in Westminster, and most exterior openings run $4,500 – $15,000 for standard window replacement or $8,000 – $25,000 for impact-rated installation, quoted in writing before any work starts. A single door slab swap or hardware replacement sits well below those figures, and we give you the line-item price up front so there are no surprises at the door. What brings most Westminster homeowners to this page is a symptom they’ve been putting off: a door that sticks every summer, a window sash that won’t latch flush, fog between the panes, or hardware that has gone loose and won’t hold adjustment. KraftMaid cabinetry is what we’re most known for, but the doors and windows around it fail on the same coastal schedule.
Bradford Remodeling Co Westminster is an independent service provider. We are not affiliated with KraftMaid, and we say that plainly so there’s no confusion about who stands behind the work. We stand behind our own installation with a written guarantee.
Which KraftMaid Models This Applies To

KraftMaid’s door and window lineup overlaps with its cabinetry finishes more than most homeowners expect, and the sizing conventions follow the same series logic. Your starting point is the label, not the internet. Interior cabinet doors carry a model or series stamp on the back of the door or inside the cabinet box. Exterior windows and doors are usually tagged at the jamb or on the frame head. If the label is gone, measure the rough opening (the framed hole the unit sits in), the unit width and height, and the sash thickness, then take photographs with a tape measure in frame. Those three numbers match a part faster than any model name.
The OEM-versus-aftermarket decision depends on the part. Hardware – hinges, handles, locksets, sash locks – we source as original-equipment whenever the spec is traceable, because a matched finish and bore pattern avoids drilling new holes. Glass units and full window sashes are where aftermarket often wins: a quality insulated glass unit built to the same argon fill and low-E spec will perform identically at a lower price, and the manufacturer warranty runs on the glass itself rather than on the installer. For a door slab or a full window, we confirm the exact series before ordering. A KraftMaid door profile with a mismatched hinge prep is the single most common compatibility gotcha we see in Westminster, so we check the hinge spacing and the bore before the order goes out. The other checkable spec: on KraftMaid cabinet doors with a soft-close hinge, the cup bore is a 35mm standard, but the hinge plate pattern is not universal across series, so a generic replacement hinge will mount and then fail to hold the adjustment you set.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your KraftMaid Windows & Doors Is Failing
Westminster sits close enough to the coast that salt air and seasonal humidity swing push on every exterior opening. Here’s what to look for and what’s actually happening underneath:
- The door sticks or drags in summer, then frees up in winter. The slab is swelling at the jamb because moisture is getting past the seal or the threshold. Left alone, the hinges and the frame take the strain.
- Condensation or fog between the glass panes. The insulated glass unit’s perimeter seal has failed and moisture has entered the cavity. That’s a sealed-unit replacement, not a window replacement, so it’s the cheaper of the two fixes.
- Draft at the sash edge or door perimeter. Weatherstripping has flattened, or the sash is out of square from frame movement. In a Westminster home over ten years old, frame movement from soil and slab settlement is common enough that we check plumb before blaming the weatherstrip.
- Hardware that won’t hold adjustment or feels loose. Screw holes in the stile have stripped, or the hinge plate pattern doesn’t match the door. This is a mounting problem, not a tightening problem, and it recurs until the right part goes in.
- Water staining or soft spots at the sill or threshold. The sill pan or flashing has failed and water is reaching the framing. This is the one symptom where delay gets expensive, because the substrate rots behind the wall and the repair grows.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

Window and door pricing in Westminster runs a wide range for a reason, and we want you to see where the money lands before you call. Here’s the range we quote, with parts and labor line-item on the written estimate:
| Scope | Installed range (Westminster) |
|---|---|
| Window replacement (single opening, parts + labor) | $4,500 – $15,000 for a full home scope; single openings price proportionally lower |
| Impact window installation | $8,000 – $25,000 |
| Door hardware or sash hardware swap | Quoted line-item per unit; below the window range |
| Sealed glass unit replacement | Quoted per pane; typically the lowest-cost fix on this page |
What moves the number up or down: unit size, glass spec (low-E, argon, laminated), whether the frame is sound or the rough opening needs repair, and how many openings you’re doing at once. A full window replacement generally takes one to two days per opening; a glass unit swap is a same-day visit. Every window and door job we complete carries the 365-Day Done Right Promise, which means a full year of written coverage. If the installation fails inside that window – a leak, a bad seal, a hardware failure – we come back and correct it at no charge. Parts are backed by the manufacturer’s own warranty on the unit we install.
A quick word on where the other brands fit: we also install Cambria and Silestone surfaces and Kohler fixtures, so if a window replacement is part of a larger whole-home remodel, the finish schedule stays consistent and traceable.
DIY or Call Us?
Some of this you can safely check. The hardware is where a homeowner can do useful work: tighten the visible hinge screws, test the sash lock with the window closed, inspect the weatherstripping for cracks and gaps, and look for water staining at the sill. What we would not recommend is replacing a window or a door slab yourself. The danger here isn’t the glass; it’s the wall. When you pull a window out of the rough opening, you’re dealing with flashing, sill pan, and the water-resistive barrier. Those three layers are what keep water out of your framing. A window reinstalled without a properly lapped sill pan will leak – quietly – for years before the rot shows. Door slabs are just as unforgiving: a slab replaced with the wrong hinge prep or without a level threshold will drag and eventually warp, and the door is the heavier of the two to lift and align.
If a door is sticking, a sash is fogged, or water is staining the sill, call us at (833) 954-5086 and we’ll talk through what you’re seeing before you lift a tool. Calls are answered by a live person, not a queue. If it’s a five-minute hardware fix you can handle, we’ll tell you so.
Frequently Asked Questions

Glass units typically hold their sealed cavity for 15 to 20 years, and door hardware and weatherstripping are usually the first to go, often in the 8 to 12 year range. The frame and slab itself can serve well past that if the flashing and threshold stay sound. In Westminster’s climate, the coastal humidity swing accelerates the hardware and weatherstripping timeline, so expect the low end of that range. If you’re past ten years on original hardware, the question is when it fails, not if.
Yes, more often than not. Fogged glass is a sealed-unit swap, not a full window replacement. Loose hardware is a part swap once the hinge plate pattern is matched. Sticking doors are often a hinge or threshold fix. We’ll tell you honestly which one you’re looking at, and we quote both repair and replacement on the same written estimate so you can decide with real numbers. Call (833) 954-5086 for a free estimate.
A single glass unit swap is typically a same-day visit of a few hours. A full window or door replacement runs one to two days per opening once the unit is on site. The job timeframe includes setting the unit, flashing, and finish, not just the swap. We’ll put the schedule on the written estimate and stick to it.
We start with the label and the rough-opening measurements, then confirm the series before ordering. Hardware and hinges come original-equipment where the spec is traceable; glass units and sashes come built to the same low-E, argon, and glazing spec as the original. We work with a documented roster of name-brand materials, so specifications are traceable and quality isn’t left to guesswork. If the exact KraftMaid part is discontinued, we source the closest equivalent and tell you exactly what changed. Call (833) 954-5086 to start the measurement visit.
If you’re ready to price a window or door repair in Westminster, call (833) 954-5086 for a free estimate and a written price before any work starts. Bradford Remodeling Co Westminster operates to The Garrison Standard, which means background-checked, uniformed technicians on every job, a written price before the first tool comes out, and the 365-Day Done Right Promise on every completed project. When we leave, the site is clean, the scope is documented, and the signed guarantee is in your hand.
Written by the team at Bradford Remodeling Co Westminster, serving Westminster and nearby areas.












