







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
CWS Driveway & Pavers: The Westminster Owner’s Guide
We install and repair CWS-compatible driveways and paver systems across Westminster, and most full paver driveway projects run $7,000 – $18,000 installed, while a concrete driveway sits at $4,500 – $12,000. A failing section – a settled corner, a lifted paver field, a crumbling edge – usually costs far less to correct than owners fear, and we can give you a written number before any work begins.
Owners in Westminster typically discover the problem the same three ways: a paver rocks underfoot near the garage apron, water pools against the foundation after a rain instead of running to the street, or a hairline crack in the slab widens over a single dry season. CWS paver systems are modular, so a failed field is often a section repair, not a tear-out. That distinction is the whole ballgame on cost, and it’s the first thing we check when we walk a property in Westminster.
Key Takeaways
- Most CWS paver driveway work in Westminster falls between $7,000 and $18,000 installed; repair of a failed section is usually a fraction of that.
- Paver failures are almost always a base (substrate) problem, not a paver problem – the block itself rarely fails.
- Concrete and asphalt driveways have different failure modes and different repair economics than pavers.
- We pull the written price together before the first tool comes out, and every completed job carries the 365-Day Done Right Promise.
Which CWS Models This Applies To

CWS has shipped paver and hardscape systems across several product lines, and the compatibility question usually comes down to paver thickness and profile rather than a model number stamped in stone. Thickness is the spec that matters most: standard driveway pavers run about 2 3/8 inches (60mm), while pedestrian-rated patio pavers are often thinner at roughly 1 3/4 inches (45mm). Putting a patio-thickness paver into a driveway field that takes vehicle loads is a common and expensive mistake, and it’s one we check for on every Westminster property we look at.
To identify what you have, measure a paver at an exposed edge near the garage apron or a control joint, note the color family and surface texture, and check whether the field sits on a compacted aggregate base or a concrete slab. That base detail tells us more about what will work than any label. Where a CWS paver profile is discontinued, we match thickness, color family, and joint spacing with a quality equivalent rather than forcing an exact part that no longer exists. We work from a documented roster of name-brand materials – including Belgard and Unilock hardscaping alongside KraftMaid, Cambria, and Silestone on the interior side – so specifications stay traceable and nothing is left to guesswork.
One honest note: Bradford Remodeling Co Westminster is an independent service provider and is not affiliated with CWS. We install and repair CWS-compatible systems, and we’ll tell you plainly when a repair makes more sense than a match.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your CWS Driveway & Pavers Is Failing
Paver and driveway failures telegraph themselves early. Here’s what we see in Westminster and what each symptom actually means underneath:
- Pavers rocking or shifting underfoot. The bedding sand has washed out or the base didn’t compact fully, so the block loses support. A rocking paver is a base warning, not a surface cosmetic.
- Sunken or heaved sections near the garage apron. Westminster’s clay-heavy soils swell when wet and shrink when dry, and that movement lifts and drops the field seasonally. A settled corner after a wet winter is the classic signature.
- Water pooling against the house or in the driveway field. The slope has drifted out of tolerance, so drainage now runs toward the foundation instead of the street. This one compounds – standing water speeds base deterioration and can reach the slab.
- Crumbling edges, joint sand loss, or weeds pushing through joints. Edge restraint has loosened or the polymeric joint sand has eroded, letting the field spread and moisture in. Left alone, the whole perimeter starts to migrate.
- Widening cracks in a concrete or asphalt driveway. Concrete slabs crack at control joints or from base settlement; asphalt develops alligator cracking as the binder ages and water gets underneath. Both point to the same underlying question: is the base still doing its job?
Replacement Cost & What’s Included

Here’s the honest range for Westminster, with what drives each number:
| Project | Installed Price Range | Main Cost Drivers |
|---|---|---|
| Paver Driveway Installation | $7,000 – $18,000 | Square footage, paver profile, base depth, edge restraint |
| Concrete Driveway Installation | $4,500 – $12,000 | Slab thickness, reinforcement, finish, joint layout |
| Asphalt Driveway Paving | $3,500 – $9,000 | Base prep, asphalt thickness, compaction, seal coat |
| Driveway Replacement | $5,000 – $14,000 | Demo and haul-off, base rebuild, new surface |
| Driveway Sealing | $250 – $700 | Surface area, prep, sealant type |
The range moves on square footage, how much base has to be rebuilt versus reused, and access – a tight Westminster lot with limited staging costs more in labor than an open driveway. We give you a written, line-item price before any work starts: parts and materials, labor, demo and haul-off, and permits where they apply, all broken out. No numbers that move at the door. Every completed driveway and paver project carries the 365-Day Done Right Promise – a full-year written guarantee, and if the work fails inside that window, we come back and correct it at no charge.
See the difference
Before
After
Before
After
Before
AfterDIY or Call Us?
Some things an owner can safely check: measure a paver’s thickness at an edge, note where water pools after rain, look for loose edge restraint, and photograph cracks so you can tell whether they’re growing. That’s useful information, and it helps us quote faster.
Where DIY goes wrong is the base. Pulling and resetting a paver field without compacting the substrate to proper depth just recreates the same failure a season later, and re-leveling a slope so water drains correctly takes equipment most homeowners don’t have. On concrete and asphalt, patching over a failed base hides the problem for a few months at best. Our technicians have up to 22 years of experience reading exactly this kind of failure, and we’ll tell you honestly whether you’re looking at a section repair or a rebuild. Call (833) 954-5086 for a free estimate – a live person answers, day or night.
FAQs

A properly installed paver driveway typically lasts 25 to 50 years, and the pavers themselves often outlast the base beneath them. In Westminster’s clay soils, the base and drainage are what determine real lifespan – a driveway built on a shallow, poorly compacted base can fail in five to ten years regardless of paver quality. Call (833) 954-5086 and we’ll assess your base and give you a straight answer.
Yes – paver driveways are modular, so a settled or rocked section is often repaired by lifting the affected field, correcting the base, and resetting. Full replacement usually only makes sense when the base has failed across most of the driveway or the slope can’t be corrected section by section. Call (833) 954-5086 for an exact quote – estimates are free.
A section paver repair is commonly a one-to-two-day job, while a full driveway replacement runs several days depending on square footage, base work, and curing time for concrete. We schedule it, put the timeline in writing, and tell you what to expect each day. Call (833) 954-5086 to walk through your project.
We match your existing paver by thickness, color family, and joint spacing, and source from documented name-brand manufacturers – including Belgard and Unilock hardscaping – so specs and manufacturer warranties stay traceable. Where an exact CWS profile is discontinued, we identify the closest quality equivalent and show you the match before ordering. No parts are carried on our trucks; everything is specified and ordered for your job. Call (833) 954-5086 for a free estimate.
Get Your Written Price
A failed driveway doesn’t fix itself, and you shouldn’t have to guess at the number. We’ll walk your Westminster property, measure the field, check the base, and hand you a written, line-item price before any work starts – backed by the 365-Day Done Right Promise and a background-checked, uniformed crew you know by name before they arrive. Part of the Garrison Partners family and held to The Garrison Standard, we’re an independently owned and operated business that puts every price and every guarantee in writing. Call (833) 954-5086 today for your free estimate.
Written by the team at Bradford Remodeling Co Westminster, serving Westminster and nearby areas.












