







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Tremron Home Additions & ADU: The Westminster Owner’s Guide
Tremron-compatible home additions and ADUs in Westminster typically run $45,000 – $130,000 installed, with ADU construction and garage conversions landing in the same range; we price the whole job in writing before any work starts. Most Westminster owners don’t discover a failure in a trim or finish component on a Tremron-specified addition until a caulk line opens, a piece of fascia or a decorative hardscape unit lifts, or a freshly finished ADU fails a final inspection because a rated assembly wasn’t installed to spec. When that happens, the question stops being cosmetic and becomes: which exact component matches the Tremron assembly on this job, and who installs it correctly the first time.
Key Takeaways
- Installed price for a Tremron-compatible addition or ADU in Westminster: $45,000 – $130,000.
- Garage conversions run $30,000 – $80,000; full ADU builds run $90,000 – $220,000.
- We are an independent service provider, not affiliated with Tremron.
- Every project gets a written price before tools come out and the 365-Day Done Right Promise in writing at close.
Which Tremron Models This Applies To

Tremron is a masonry and hardscape manufacturer, so a home addition or ADU specified with Tremron means the hardscape units, retaining wall blocks, steps, and sometimes the decorative veneer and pavers around the structure. Compatibility is about matching unit profile, thickness, and color lot, not about which “model” of addition you built. Pull the unit from the pallet band or the stamped grid on the underside of a paver and note the profile name and dimension; the printed band is the only reliable identification for a Tremron unit, and color lots vary between production runs, which is the gotcha that catches most owners. A replacement unit from a different lot can read as a slightly different shade a season after installation.
The OEM-versus-aftermarket decision breaks down here. Tremron factory units carry the exact dimensional tolerance and a documented color. A quality aftermarket hardscape equivalent can work well, but only if the thickness and joint width match what the wall or walkway was engineered for; a few millimeters of drift shows up as a shifting joint within two seasons of Westminster’s summer heat and winter sheet flow from the marine layer. We confirm the profile before ordering and document the specification on the written scope so nothing about the finish is left to guesswork.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Tremron Home Additions & ADU Is Failing
These are the symptoms we actually see on Westminster additions and ADUs that were built around a Tremron-specified assembly:
- Open or receding joints between hardscape units. Joint sand washes out at the first hard rain, and sunlight cracks the polymeric joint if it wasn’t placed to the correct depth. This is the most common failure on the decorative apron and entry walk around an added room.
- Fascia or decorative fascia board lifting at the eave. Usually a sign the trim board was nailed to a moisture-swelled substrate instead of to spec, which is common where a two-story addition meets the existing roofline and soffit.
- Trim or door threshold pulling away from the wall. Almost always a moisture-management failure inside the assembly, not a bad Therma-Tru door. The threshold detail lets water wick in and the substrate swells behind the trim.
- Small cracks or efflorescence on masonry veneer or step faces. Efflorescence is the white crust left when salts migrate out. It points to a wall that is holding water because the drainage plane behind the assembly was skipped or the weep provision is blocked.
- Sliding or sticking casement window or a gap at the frame. Common when a window was set into a rough opening that drifted out of square during the addition. Note the frame gap before calling it a window failure.
If you want a second set of eyes, this is information, not a scare tactic: a failing hardscape joint or trim detail is fixable, and diagnosing it before water gets behind the fascia saves real money on a Westminster addition that is otherwise sound.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

On a Tremron-specified addition or ADU in Westminster, we price the whole job, not a bare part: $45,000 – $130,000 installed for a typical home addition and ADU scope. A garage conversion runs $30,000 – $80,000, and a full stand-alone ADU build runs $90,000 – $220,000. The low end is a modest addition on a level lot with an easy utility tie-in. The high end covers a two-story addition, a full ADU with its own utility service and kitchen, and a Westminster site with tight access.
What drives the range: structural design and engineering, the utility rough-in (electrical, plumbing, HVAC), foundation and weatherproofing, hardscape and finish, and permits with inspection. The written price covers parts and labor together, itemized line by line, with no number that moves at the door. Our technicians have up to 22 years of experience on additions and ADUs, and every completed job carries the 365-Day Done Right Promise: if the work fails inside a full year, we come back and correct it at no charge.
For context on other scopes around the same Westminster home, a kitchen remodel runs $14,000 – $45,000, a bathroom remodel $9,000 – $28,000, and a paver patio $3,500 – $11,000. We also install and service product from documented brands including KraftMaid, Cambria, and Silestone, so your specifications stay traceable to manufacturer warranty.
DIY or Call Us?
The honest split. An owner can safely check a handful of things without touching the structure: inspect the caulk and joint sand for gaps, look for fresh white crusting on masonry (efflorescence), check whether the window and door frames sit flush, and note where water sheds off the addition after rain. What goes wrong in DIY is the structural and weatherproofing side: re-specifying the wrong hardscape unit, refilling joints without confirming the correct depth, and re-flashing the transition between an addition and the original roof. A re-flash or a bearing correction is where a homeowner with a caulking gun ends up with a callback and an insurer asking why the assembly was altered. That work belongs with a trained, insured professional.
Where DIY is safe: cosmetic touch-up on hardscape joints once the correct unit is confirmed, and documenting the failure for the record. Most of this work we would recommend you not take on yourself. Call (833) 954-5086 to schedule your free estimate, and a live person answers the phone 24 hours a day, 7 days a week. We confirm the exact Tremron-compatible profile before we order, give you the price in writing, and every project is covered by our written guarantee at close.
FAQs

A well-built addition or ADU should hold its hardscape and finish for 15 to 30 years; problems show up when something was skipped at the assembly, not because the Tremron product itself aged out. Westminster’s marine layer is wet in the morning and warm by the afternoon, and that daily cycle is what opens cracks and joint failure early; an assembly specified for it correctly holds. Call (833) 954-5086 for a free estimate if you see any of the signs above.
Often yes, and we check first. A re-pointed joint or a repaired trim piece on an otherwise sound assembly is cheaper than a full replacement. A cracked hardscape unit or a moved component that has opened a drainage plane behind the wall usually needs replacement of the failed piece. We look, diagnose, and give you the honest answer: repair when repair is right, replace when it’s not.
A repair to a single joint or trim detail is typically a day or two on site. A component replacement on a Tremron-specified assembly we can complete once the correct profile is confirmed and delivered, typically within a week or two of the estimate. A full addition or ADU scope is measured in weeks and months, and your written scope lists the schedule milestone by milestone.
We match the printed pallet band or stamped grid on the unit, confirm the profile, thickness, and color lot, and document it on the written order back to the manufacturer’s product line. Every part we install is confirmed against the spec on your job, not guessed from a photo. For your part in Westminster, call (833) 954-5086 and estimates are free.
Written by the team at Bradford Remodeling Co Westminster, serving Westminster and nearby areas.












