







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Therma-Tru Bathroom Remodeling: The Westminster Owner’s Guide
Therma-Tru bathroom doors and door systems are engineered as a matched assembly – slab, frame, hinges, sweep, and finish – so a “part” here is rarely a single generic piece. In Westminster, a bathroom remodel that keeps or replaces a Therma-Tru door or entry system typically runs $9000 – $28000 installed, depending on scope, and we schedule the work as a planned project, not a same-day swap. Owners usually discover a failure the same way: the door stops latching cleanly, the bottom sweep drags and leaves a water line on the tile, or the paint on the slab edge starts to bubble after a wet winter.
Key Takeaways
- Therma-Tru parts are matched to a specific series and rough opening – guessing is how homeowners end up with a door that won’t square up.
- The bottom sweep and the hinge-side weatherstripping fail first in Southern California’s dry-then-damp cycle, not the slab itself.
- Full bathroom remodel pricing in Westminster: $9000 – $28000. Written price before any work starts, every time.
- We’re an independent service provider and not affiliated with Therma-Tru. We install documented, spec-traceable materials.
Bradford Remodeling Co Westminster is an independent contractor, not affiliated with Therma-Tru. We work from a documented roster of premium brands – Therma-Tru doors alongside KraftMaid and Wellborn cabinetry, Cambria and Silestone surfaces, Kohler and Moen fixtures – so every specification is traceable back to the manufacturer.
Which Therma-Tru Models This Applies To

Therma-Tru’s bathroom and interior door lines are grouped by series, and the series determines the slab thickness, the hinge pattern, and the rough-opening tolerance you’re building to. The homeowner’s job is not to memorize model numbers – it’s to hand us the right identifying information so the part matches on the first visit.
Here’s how to identify what you have before we arrive:
- The label on the door edge or top jamb. Therma-Tru ships a label with the series and size. Check the hinge side and the top of the frame – it’s often painted over and needs a light scrape to read.
- The rough opening. Measure width, height, and wall thickness to the nearest 1/8 inch. A 32-inch door and a 34-inch door are different assemblies, not the same one trimmed down.
- Handing. Left-hand vs. right-hand inswing is stamped or marked. Getting this wrong means a door that swings into the vanity instead of past it.
On the OEM-versus-aftermarket question for a Therma-Tru system: aftermarket sweeps and weatherstripping are fine and widely used – they’re wear items, and a quality aftermarket sweep that matches your door thickness does the job. What we don’t recommend is an aftermarket slab dropped into an OEM frame, or an OEM slab forced into a frame that’s out of square. The frame is the measuring standard; once it’s twisted, the whole assembly fights you.
Westminster’s housing stock runs from mid-century ranch homes near the civic center to newer builds toward the Little Saigon corridor, and door sizes reflect that spread. Bring us the label and the rough opening and we’ll confirm the match before anything is ordered.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Therma-Tru Bathroom Remodeling Is Failing
A failing door assembly shows itself in specific, checkable ways. Here are the five we see most in Westminster bathrooms, with the cause behind each.
- The door drags on the floor or tile. Usually a sagging top hinge or a frame that has shifted with seasonal movement. Dragging grinds the sweep and eventually the slab edge.
- The bottom sweep is cracked or missing. The sweep is the first wear item to go, especially in a bathroom where humidity swings. A failed sweep lets water and air past the threshold.
- The door won’t latch or the strike misses. A strike plate out of alignment, often because the frame has settled. Left alone, the latch chews the jamb.
- Paint bubbling or peeling on the slab edge. Moisture wicking into an unpainted edge or a failed seal. Once water gets into the substrate, the damage spreads.
- Daylight or a draft around the closed door. Weatherstripping that has compressed or pulled loose. In a bathroom this also means conditioned air and moisture are escaping into the wall cavity.
If two or more of these are showing at once, the assembly is usually out of square and a single-part fix won’t hold. That’s when a small bathroom remodel scope ($5000 – $12000) makes more sense than chasing parts.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

In Westminster, a bathroom remodel that replaces or rehangs a Therma-Tru door and brings the surrounding assembly back into square typically runs $9000 – $28000 installed. Smaller-scope work – a door swap and threshold correction inside an existing bathroom – lands in the $5000 – $12000 small bathroom remodel range.
What drives the number up or down:
- Scope. Door only versus door plus tile, vanity, and shower surround. The wider the work, the more the rough opening and framing have to be corrected.
- Frame condition. A plumb, square frame is a quick install. A settled or water-damaged frame means framing work and re-finishing before a new door goes in.
- Material and finish spec. The slab finish and hardware you choose move the number.
Every Bradford project gets a written price before any work starts – the number doesn’t move at the door. Parts and labor are itemized, so you see what the door assembly costs versus the surrounding work. All completed work is covered by the 365-Day Done Right Promise: if the work fails inside that first year, we return and correct it at no charge.
DIY or Call Us?
There are checks a homeowner can safely do. Read the label on the frame. Measure the rough opening. Photograph the sweep and the weatherstripping. Note whether the door is left- or right-handing. None of that involves lifting a slab or pulling a frame, and it makes the estimate faster and more accurate.
Where DIY goes wrong is at removal and rehang. A bathroom door slab is heavier than it looks, it sits in a frame that may already be out of square, and reinstalling it wrong turns a $200 part into a $2,000 framing repair. There’s also a real moisture risk: a door that’s not sealed and shimmed correctly lets water into the wall cavity, and that damage doesn’t show up until the drywall softens. This is not a job to learn on. If your door is dragging, won’t latch, or the sweep has failed, call (833) 954-5086 and we’ll schedule a free estimate.
FAQs

The slab itself typically holds for decades, but the wear items – the bottom sweep and the weatherstripping – age faster. In Southern California’s dry-then-damp cycle they can need attention inside a few years. Call (833) 954-5086 for an exact quote – estimates are free.
Often, yes. A sweep, weatherstripping, hinge, or strike plate can be replaced without touching the slab, and that’s the work we do most. If the frame is twisted or the slab edge is water-damaged, a repair won’t hold and we’ll tell you so in writing. Call (833) 954-5086 for a free estimate.
A single door-part swap is typically a few hours. A full door or door-plus-bathroom scope is a scheduled project, and we’ll give you the timeline in writing before we start. No surprise move on the schedule. Call (833) 954-5086 to schedule your free estimate.
We source through documented manufacturer channels and confirm the series, size, and handing against your door’s label and rough opening before ordering. You get the part spec and the price in writing – no guessing at the counter. Call (833) 954-5086 for an exact quote.
For a bathroom remodel in Westminster that involves a Therma-Tru door or assembly, call (833) 954-5086 for a free estimate. We answer live, 24/7. You’ll get a written price before any work starts, uniformed and background-checked technicians on the job, and the 365-Day Done Right Promise on the finished work. Our technicians have up to 22 years of experience, and Bradford Remodeling Co Westminster is part of the Garrison Partners family, held to The Garrison Standard.
Written by the team at Bradford Remodeling Co Westminster, serving Westminster and nearby areas.












